Vello Freewave User Manual

FREEWAVE PLUSUSER MANUAL

101. Turn on the Receiver by pressing and holding the Power button until the LED lights up.2. Set the Transmitter to Self Timer mode.3. Set your camer

111. Turn on the Receiver by pressing and holding the Power button until the LED lights up.2. Set the Transmitter to Bulb mode.3. Set your camera to t

121. Turn on the Receiver by pressing and holding the Power button until the LED lights up.2. Set the transmitter to Continuous Shooting.3. Set your c

131. Turn on the Receiver by pressing and holding the Power button until the LED lights up.2. Set the Transmitter to Bulb Shooting.3. Set your camera

14The FreeWave Plus Receiver can also be used as a wired, o-camera shutter release.With your camera and receiver OFF, connect the shutter release cab

151. Set your camera to the Continuous Shots setting.2. Press and hold the Receiver’s shutter release button halfway to wake or focus 3. A full press

161. Set your camera to Bulb mode.2. Press and hold the Receiver’s shutter release button halfway to wake or focus your camera (if set to Auto Focus).

17RCC-N2RCC-P1RCC-O2RCC-N3RCC-O1RCC-S1RCC-C1RCC-N1RCC-C2The FreeWave Plus includes a Camera Release Cable that enables the remote to work with certain

18Transmitter ReceiverPower 2 x AAA 2 x AAABattery Life 3 Year s 300 HoursChannels16 ChannelsRange100m (320 ft.) with no obstructionsFrequency 2.4 GHz

19This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause

2Thank you for choosing the Vello FreeWave Plus Wireless Remote Shutter Release. This device triggers your camera in either wired or wireless mode, al

Limited One-Year WarrantyVello provides a limited warranty that this product is free from defects in materials and workmanship to the original purchas

32.4GHz Radio Frequency: Reduced interference and improved wireless signal quality.Extended Range: up to 100m (320 ft.)16 Possible Channels: One trans

4Set the DIP switch located in the battery compartment of the Transmitter and Receiver. The DIP switches set a dierent radio frequency for each Trans

5• There are no user-serviceable parts inside the devices. Do not attempt to disassemble or perform any unauthorized modification.• Do not operate th

6FEATURES DIAGRAMBattery Compartment1 Single Shot2 Continuous Shooting3 Bulb Shooting4 Self TimerMode SelectorBattery CompartmentPower ButtonConfir

7Tur n ON the Receiver: Press and hold the Power button for 2 seconds. The LED will flash red at 2 second intervals to indicate that the receiver is wo

8If using the FreeWave wirelessly, mount the Receiver on your camera’s hot shoe, facing forwards or backwards. If your camera’s hot shoe is in use, yo

91. Turn on the Receiver by pressing and holding the Power button until the LED lights up.2. Set the Transmitter to Single Shot.3. Set your camera to